Case / Box Work In Progress Part 2

Squaring up the end of the slot with a chisel

Custom Made Case Notary Public Stamp Seal Press Pt 2

Night time workshop goings ons!

  • Fitting the base
  • Fitting the Lid
  • Shaping the Raised Panel

Some more work in progress photos of the Stamp/Seal box. In this post I will show the steps involved in fitting the base and lid into the slots as well as fitting the solid brass plaque into the top.

Squaring up the end of the slot with a chisel
Extending the slot length into the dovetails and squaring up the end without breaking through! Just a nudge with the palm is enough, this QLD Maple works well with sharp hand tools.

It’s little things like this that take the extra time — I like to sneak up on the fit rather than create a slot that’s slightly too wide or too deep, there’s nothing worse than getting half way through the glue up only to find something is slightly out of line or the base bottoms out in the slot and throws the whole thing out of square.

It can be very hard to correct once you have glue on the tight fitting dovetails, so preparation is key.

Read more

Related Images: